御诺立基 磁性粉末

4種類のメッシュ範囲

既存の仕様を選択するか、クラッチ・ブレーキの完全な型式をお知らせください。

同じふるい規格では数値が大きいほど通常は細粒ですが、細かいほど適切とは限りません。ふるい規格、粒度分布、設備条件を合わせて確認します。

設備内の使用箇所を確認

磁粉クラッチ・ブレーキを使用する箇所が対象です。サーボや空圧などの張力装置では磁性粉末を使わない場合があります。

注文前の5つの質問

粉末性能とメンテナンス

Magnetic powder is the working medium in a particle clutch or brake. Excitation changes the magnetic field and torque transmission in the working gap. Performance also depends on the magnetic circuit, clearance, cooling and controller.

点検・交換の目安

Reduced torque, unstable tension, excess heat or caking call for checks of excitation, controller, cooling, contamination and powder condition. Replacement intervals depend on actual duty.

交換前の準備

1. Record the full component model, rated torque and unit, original powder specification and symptoms.
2. Stop and isolate the equipment, prevent unexpected starting and allow it to cool. Use personnel familiar with the applicable maintenance instructions.
3. Confirm the prescribed fill amount and cleaning procedure; inspect the working gap, seals and bearings. Do not mix formulations or old and new powder without confirmation.
4. Weigh, assemble and run in according to the model instructions. Check current, torque or tension and temperature before returning to service.

保管と注文

Keep powder sealed, dry and clean, with batches labelled. Record pack weight separately from the prescribed machine fill weight. Send the component model and previous specification to YUNUOLIJI for confirmation.

Composition, particle distribution, temperature range and fill amount follow the selected grade and the specific equipment documentation.

選定条件を見積依頼に整理

設備・部品型式、トルクと単位、既存の粒度、症状、数量をお知らせください。御诺立基が適合仕様、価格、納期、送料を確認します。